E 1 message on Paragon SC2

[Edi (Edith)]

Hello everyone I have my daft head on today and my kiln, paragon SC2 is showing E1 whan i turned it on, I havent noticed it before. I only use it 2 or 3 times a year because I only do making beads as a hobby. I have looked at the manual that come with the kiln but cant find anything. 
Am I stupid or does it normally start with E1 I cant remember it doing it before.

Edi

[Glassy Lou]

Never seen it on mine but I just did a quick google and found this:


E1 is the software version of your Sentry Xpress 4.0 controller. It is not an error code. Earlier versions of the controller did not show the software version on start up.

HTH

[flame n fuse]

Yes, I'm pretty sure it's a software code before 'idle' appears. I don't think it's anything to worry about.

[Blue Box Studio]

Think mine says F1, so as long as it seems to work I'd not worry.  Never realised what the code was though.

[Edi (Edith)]

Oh thank you everyone panic at number 3 over with.

edi

[Lee - Kilncare]

Yeh, as I have just replied on the MAXI error thread. Almost all electronic controllers display their software version on power up.
Nothing to worry about that one.