Any idea what kiln this is?

[anditsinthefish]

Yep simples. The KCR1 has two sockets on it. One is a 13 amp standard 3 pin that the kiln plugs into.

The smaller socket on the side of the KCR1 is where the kilns thermocouple plugs into and tells the KCR1 how hot the kiln is.
The plug that is fitted to the end of the thermocouple cable is quite small.
Looking at the picture I can see that the cable on the thermocouple at present is the old, thick heat resistant type and this may be too fat to fit into the little plug.
It may mean swapping the thermocouple cable as well to the new, thinner type.

Hope that helps.

Is this something you would do Lee? And what sort of cost are we looking at? Thanks x

[Lee - Kilncare]

Yeh we can send you a couple of metres of the correct cable with a mini plug on the end.
You would need to get someone to connect it to the thermocouple but that is only two wires to connect in a simple terminal block.

It would cost £22 plus carriage and V.A.T. so that would be a total of exactly £30.00