settings on oxycon ...help needed

Started by sarah t, December 10, 2010, 11:54:08 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

sarah t

i think someone has fiddled with the setting on my oxycon  >:(      the twisty silver/black knob on the pressure indicator ?  down the side

do i need to re set it ?...... more imprtant how do i re set it  and what should it read ?....it is connected to the torch at the moment

any help appreciated ...thanks

once i have made these blinkin christmas presents i promise to find out all my euipment works honest  ::)

ScarletLeonard

I don't use one but yay for the man on oxygen that I care for.

If your l/min has been fiddled with it's just a case of turning the knob to the required amount of oxygen (which for the torch I believe is 5 litres./ 10 for boro.)
You should have a guiding line that moves up and down when you turn the knob, then when you switch it on a little ball will float up to the set level.

Anyone that knows better please correct me.

♥♥Tan♥♥

Why do you think someone has fiddled with it Sarah is the torch pressure down? The round dial should have a curvy triangle on it the pointy end is for less flow and the wider end is for more, as Scarlett has said.

I think the reading is particular to everyones set up but I adjust mine by turning it to full and then dialing it back down until I have the flame I want then just leave it at that for each time. If you look at your gauge to see where the ball is and mark it with a marker pen it will remind you in the future

Redkite

I was recommended to light the torch, open the oxygen valve up completely, then use the knob on the oxycon to adjust the flow to the correct flow rate. I use 4-5 lpm on my cricket, depending on how bushy I want my flame ( I think most torches need the full 5) . Then you can adjust the propane at the torch to get the correct looking flame. After that, you don't need to adjust the oxycon at all.

sarah t

thanks everyone ..i have never touched this button since i got my oxycon so martin set it and thats where it stayed.. i regulate from my torch ?.....
but my oxycon seams very poorly  :(  its really slugish and not getting up enough pressure (not getting beyond about 3) and is stll producing air not oxygen after running for about an hour (according to sally who said this was its problem from thread about flame being pushed away from the torch ) and the bleeps after about 20 mins ''service  required '' flashing ...it has done this before but usually just turning it off then on sorts it out ....i have a feeling it may be terminal .....or will need a some attention from Dr Tuffnel ...but that wont happen till after christmas and i was hoping to get christmas presents done before then !