Fusing in Bead cube

[Passionatelamper]

Could someone pullease......give me the program to fuse glass in the Bead cube... I put a load in yesterday... dived to the kiln this morning. All still the same as when it went in...Bah!!!! Please .......need the exact program for the bead cube....I am desperate....

[cbeadies]

  Sorry I don't know about fusing schedules, although I would quite like to know too as I also have a beadcube... just wondering whether Lee at Kilncare could help, they are usually very helpful there.

[aercraft]

I've just been doing exactly this - will dig out the programme.  Are you using bullseye?

[Passionatelamper]

I am using Dichroic Glass to make cabs thank you   I have sent an email to Brian at Kilncare but no reply yet :-}

[aercraft]

This is the programme I used last for Bullseye:

  1. ↑ 222 to 670, hold 20min
  2. FULL to 804, hold 10min
  3. FULL to 482, hold 30min
  4. ↓ 80 to 371, no hold
  5. FULL to 93, no hold
  6. End

Step 1 is a bubble squeeze and only short as I was doing small pieces.  The temps and times are based on the info on the Bullseye site and I got some good results with this programme.  Takes 9 hours.

[Passionatelamper]

Thank you soooo so much I will do that many many thanks...