Oxycon problem

[amareargentum]

I'm hoping that someone with more experience can tell me if I have a problem here.

I have an Oxycon that I bought a few months ago from Q.So far I have only had a couple of chances to spend a long time beading (5 hours or more). On both occasions, right at the end of the session my flame has started flaring - like there is momentarily less oxygen. Is this a problem with the oxycon or is it just getting tired. I work in a shed which has good ventilation and my oxycon isn't under the bench when I am using it, so I don't think I have a problem with not enough air getting to it.

Any suggestions would be gratefully received.

Amanda

[Dragonfire Glass]

Its possible its overheating, although I'm no expert.
You could try cleaning the filters.
Have you emailed Q?

[amareargentum]

No, not yet. I wasn't sure if this was normal or a problem. I will drop him a line.
Thanks for your help
Amanda