So I've had a couple of goes, and I think we will eventually become very good friends, but by golly it's different. I think i've got my neutral flame ok, but the flame "fingers" are taller on one side than the other. I cleared out the holes with the wire that came with it, and it was all level for a little while, but next time I lit it, the same thing. Is this something to worry about?
That sounds a bit odd. Mine has very even fingers.
I did read that they can take a while to settle down, that you have to adjust the oxy/fuel whilst using it sometimes, maybe that's the problem.
I think JulieHB has one and may have written about its peculiarities.
I seem to have quite a well behaved one and if it did require adjustment to start then I didn't actually know I was sorting it :P
I've just come across this tread about Bobcats
http://www.frit-happens.co.uk/forum/index.php?topic=27229.15
Haven't read it all but there might be something in it to help you.
Mine would constantly get deposits on the torch face, causing an irregular flame. Simply sweep off with a pointy tool or the end of your mandrel.
Thanks folks I'll give it a try