I've lost my (read Peter's) pipe cutter and was wondering if anyone had any tips on cutting metal tubing straightly, mine seem to be edging slightly to one side so one side of the tube is longer than the other! ::)
Masking tape. Wrap round so the ends match and use as a guide.
Buy another pipe cutter - dead cheap!
You know those nit combs of metal, with very fine slits? If you fix one of those in the vice they make a good sawing guide as well :)
Quote from: julieHB on February 10, 2011, 09:25:32 AM
You know those nit combs of metal, with very fine slits? If you fix one of those in the vice they make a good sawing guide as well :)
A woman after my own heart Julie.
Thanks Ladies... will give these ideas a go!
Quote from: mizgeorge on February 10, 2011, 09:07:46 AM
Masking tape. Wrap round so the ends match and use as a guide.
Thank You George!!! Worked a treat!!