Is anyone else using this stuff for slumping?
Can you use kiln wash on it or do you have to stick with thinfire paper?
I've used kaiser Lee, and I used Kiln wash for the first three of four firings, I then use a bit of thinfire for the next couple just in case.
Thanks,
the shape I've carved lends itself better to wash than thinfire.
I'll give it a few coats and see what happens.
It can also be fired without kiln wash!
Pippa
Ooooo, even better :)
I have used without kilnwash, and it doesn't stick to the glass. However, the glass did pick up the texture of the Kaiser Lee board (which was quite nice!)
I *think* you can sand paper it (perhaps Pippa can confirm this) - but USE A DUST MASK!
I did rub one of the offcuts with a bit of sandpaper and that did work.
I've used the back of a blade to smooth down the areas that were cut. Quite like the texture left on the top.
But I know what you mean about the dust... and the glass splinters, great fun picking them out of my fingers.
Yes, it can be sanded - we use fine grade paper in the studio here to get a really smooth finish where desired. Definitely, as when you are using any fusing products which contain particles such as frits, powders etc, we always wear a Dust Mask and would recommend others to do likewise. At least because this stuff is prefired, it doesn't give off unpleasant fumes on firing! :) Pippa
I've tried a firing without kilnwash/paper now.
Worked quite well and did indeed pick up every bit of the texture. It also took a while to get the KLB bits out of the glass :)
I'm going to try again later with the same mold kilnwashed. It's been drying for a couple of days now.