Frit-Happens !

Fusing and Stained Glass Tips and FAQ's => Fusing Tips and FAQ's => Topic started by: dawn on March 24, 2008, 10:24:48 AM

Title: Removal of kiln wash
Post by: dawn on March 24, 2008, 10:24:48 AM
I am having trouble removing kiln wash from my work.  :-[ I have been using fibre paper but even after washing it seems to be leaving a residue behind. 

How do I get this off?


Thanks

Dawn
Title: Re: Removal of kiln wash
Post by: Zeldazog on March 24, 2008, 12:39:24 PM
How hot are you firing Dawn?  - I sometimes have kiln wash sticking in the brush mark grooves, but never had a problem with kiln paper.

Assuming you mean stuck on the back of your work, I soak mine for an hour or so in hot water, sometimes soapy - green pan scrubber.

And if that doesn't shift it, I have a sickle stone, I run the tap and rub the back of the pieces on it.  Usually works.




Title: Re: Removal of kiln wash
Post by: dinah46 on March 24, 2008, 12:52:30 PM
If fibre paper is sticking to your work I think you are probably firing too hot. Try bringing the temperature down but increase the soak time.

Sometimes it can be the glass, some of the bullseye opaques are really bad for sticking but I have not had any problems when using the fibre paper.
Title: Re: Removal of kiln wash
Post by: dawn on April 26, 2008, 01:31:28 PM
Thanks everyone - problem solved - I was using kiln wash but have now gone back to using fibre paper and it is not sticking at all. 

Dawn