Frit-Happens !

Technical Forum => Studio/workspace/setup/equipment => Torches => Topic started by: amber0307 on February 28, 2008, 10:05:45 PM

Title: Attaching Hothead to Bench
Post by: amber0307 on February 28, 2008, 10:05:45 PM
I've been reading all the posts about attaching a hothead and am a bit confused.

Could someone spell out for me exactly what I need to attach my hothead to my workbench?  ???

I have my hothead, have just bought a bench clamp from Tuffnell.  Do I need to buy any other connectors/clamps, and if so what are they called and where could I find them?!  :-\  It's very confusing.

:)

Thanks!
Title: Re: Attaching Hothead to Bench
Post by: Ilona on February 28, 2008, 11:22:38 PM
Hi,

I made a make shift strong wire clamp that I twisted round and underneath the canister. then the ends of the wire was clamped to the table.


Title: Re: Attaching Hothead to Bench
Post by: Sandra J on February 29, 2008, 08:52:41 AM
It depends if you are using Mapp or bulk, they use the same method just with different sized jubilee clips,this thread may help you.  ;)
http://www.frit-happens.co.uk/forum/index.php?topic=1795.0 (http://www.frit-happens.co.uk/forum/index.php?topic=1795.0)