Hi there
Can anyone advise me on how I might use a slow cooker to keep annealing bubbles etc warmer, & try & reduce the number of cracked beads I'm getting at the mo? I saw it mentioned on the forum & I have one here, just not sure what temp to set it...it has low/high/warm options on the switch. Do I start off high & then gradually reduce it? Also, can I mix vermiculite from the garden centre with annealing bubbles? The bag of bubbles I have only about half fills the slow cooker. Just want to give them the best chance in life!
Thanks
Kim
I did exactly that. I mixed vermiculite and bubbles. I set theslow cooker on high. After about an hour after the last bead went in, I would turn it off and not remove the beads until the vermiculite mix was about 50 degrees or cooler - it worked for me - didn't have any breakages using that system. Hope this is of help ;D
This is exactly how I did it too, but I just used bubbles and I had no dusty vermiculite.
I used a small slo-cooker from Argos that I had bought (£10) originally for my silversmithing pickle and it was small enough to get a good depth with one bag of bubbles.
Since the kiln, it's now used for it's original purpose. I have retained the bubbles though, in case I should ever need them (in case of kiln emergency)
Linda x
Hi. I used to use slow cooker and vermiculite. That worked ok. But I don't think the slow cooker likes it much over long term. I had to chuck it. Can't beat kiln if u can save up. I haven't used annealing bubbles...they weren't out then. I used to put cooker on high. Then batch anneal in my fusing kiln..the big beads didn't always make it. X
I have my annealing bubbles in a slow cooker, i put it on high when i start and turn it off when i'm finished and have lost very few beads. In my opinion as long as the bubbles are deep enough to cover the beads i wouldn't start mixing it with vermiculite, which is very dusty and not as good at holding in the heat as the bubbles.
HTH
I use a slow cooker when i don't want to turn on the kiln but never throught to actually turn it on with bubbles. Not lost anything yet, other than very large beads.
Thanks so much to you all - I have stuck them all in on high, & as you suggested, turned it off when I finished. Not going to take them out till the morning!