Frit-Happens !

Technical Forum => Studio/workspace/setup/equipment => Torches => Topic started by: Scubeadoo on August 06, 2011, 11:29:29 AM

Title: Problems with my Cricket
Post by: Scubeadoo on August 06, 2011, 11:29:29 AM
I remember a similar post a little while ago but cannot find it!

My cricket has suddenly started 'breathing' it runs o.k for a while then will suddenly 'flare' for a few seconds as if the propane has been turned up a little. It will then settle back and run O.k for a few minutes then flare again.
Eric the oxycon seems to be running normally.
I have a flashback arrestor in the propane line
Any ideas anyone

Marion
Title: Re: Problems with my Cricket
Post by: helbels on August 06, 2011, 12:01:50 PM
Have you cleaned out all his holes using the little wire you got with him?
Title: Re: Problems with my Cricket
Post by: Lush! on August 06, 2011, 12:29:39 PM
When this happens to me it seems to signal low propane or a low oxygen - but as its a Cricket, do also do as Helen suggested, as well as checking there's no obvious bits of soot that need knocking off the face of the torch.

Title: Re: Problems with my Cricket
Post by: jammie on August 06, 2011, 01:36:12 PM
This happened with my bobcat but it was the oxycon, the little ball was bouncing, can you watch to see what's happening with that.
Title: Re: Problems with my Cricket
Post by: Madam Steph on August 06, 2011, 03:14:24 PM
It will be the soot, prolly.
I often have to stop after a couple of hours and clean the holes.
I also make it part of my routine to clean after each session
Title: Re: Problems with my Cricket
Post by: Scubeadoo on August 06, 2011, 04:09:14 PM
Thanks Ladies.
Have been and poked all his little holes out as suggested :o :o
Now seems to be running quite happily.
After 2 years on a hothead which never seemed to need cleaning it did'nt occur to me that routine tlc would be needed!

Marion
Title: Re: Problems with my Cricket
Post by: helbels on August 06, 2011, 04:35:04 PM
Yep, the Cricket gets sooty.  You will actually see the soot build up on the face of the torch as you work. 

Just give him a little poke with the proddy thing every so often and all will be well!