Frit-Happens !

Lampwork => Lampworking Tip n Tricks => Topic started by: DeanWilson on February 08, 2011, 08:07:12 PM

Title: Help with Silver Core Rivets please!
Post by: DeanWilson on February 08, 2011, 08:07:12 PM
Hey guys, I have some Silver Core Rivets from Tuffnells but they don't fit inside my beads! On their site it says to make the beads on 5mm mandrels, double dipped. I did that- I dipped them more than twice to be sure and they STILL won't fit!! I even used my battery reamer to file away the inside of the beads and nothing! The rivets fit in about halfway (each) and then are hard to get out again! Do you need a hammer to beat them in or something? Driving me nuts! :(

Sorry for the rant, any help would be *phew!* greatly appreciated :P ;D

Dean ;D
Title: Re: Help with Silver Core Rivets please!
Post by: hollergrafik on February 08, 2011, 08:14:34 PM
Hiya Dean,
just ream the beads some more and then epoxy glue them in, if they are a tight fit you have less chance of them coming out again too.
Title: Re: Help with Silver Core Rivets please!
Post by: DeanWilson on February 08, 2011, 08:25:17 PM
Okay, will do thanks ;D Will just reaming the glass constantly affect the drill bits or will they be fine? This battery one spins quite fast :P
Title: Re: Help with Silver Core Rivets please!
Post by: helbels on February 08, 2011, 08:28:44 PM
I wouldn't worry about them Dean, they are cheap as chips to replace.
Title: Re: Help with Silver Core Rivets please!
Post by: DeanWilson on February 08, 2011, 08:38:59 PM
Okay, I won't ;D Although they aren't that cheap- £4.75 + £4.50 postage! Or it might be £2.50..I won't worry about them but I won't completely lose my mind either ;) ;D Thanks!
Title: Re: Help with Silver Core Rivets please!
Post by: ♥♥Tan♥♥ on February 08, 2011, 08:43:50 PM
Shop around ;)
Title: Re: Help with Silver Core Rivets please!
Post by: hollergrafik on February 08, 2011, 09:46:39 PM
ream with the tip of the reamer in water, makes them last longer. I get mine from ebay, lots cheaper
Title: Re: Help with Silver Core Rivets please!
Post by: MadelineBunyan on February 08, 2011, 10:19:13 PM
little heads up for you...the replacement bits tuffnell sells do not fit the battery reamer!

unless he has now got new ones in and has forgotten to tell me!

so you will have to get new ones elsewhere anyway, but I haven't bothered looking them up yet.
Title: Re: Help with Silver Core Rivets please!
Post by: KatheL on February 09, 2011, 03:40:43 PM
Hi Dean,

In Denmark 5,2 mm mandrels are recommended for this purpose, they are available but costly: www.ravstedhus.dk

It is available locally in one meter lenghts from where iron and steel is bought, ask your local smithy, they can order it for you if you grease them a bit.
These meter lengths are available with 0.1 mm intervals.
For more even numbers like 2, 2.5, 3, 4 mm etc. it is a lot cheaper to order full lengths of stainless steel, it comes in 3 or 6 meter lengths and cost a fraction if you are prepared to cut it yourself. Easily done with a cheap bolt cutter, ends smooth with a file.

Kathe, DK