Frit-Happens !

Technical Forum => Studio/workspace/setup/equipment => Oxycon/Oxygen/Propane => Topic started by: Mand on February 05, 2011, 03:38:12 PM

Title: Whoops!
Post by: Mand on February 05, 2011, 03:38:12 PM
I forgot to switch off my oxycon yesterday afternoon.  I went out to the shed just now and discovered it chugging away happily.  So, it's been on for about 24hrs! Eek!  Will this do it any harm??  :( :-[ :P
Title: Re: Whoops!
Post by: Shirley on February 05, 2011, 04:25:35 PM
I doubt it. When Martin sets them up he leaves them running all day to make they are ok. It's probably done it good!
Title: Re: Whoops!
Post by: Redhotsal on February 05, 2011, 05:54:20 PM
I would think it would be fine. They're meant to be kept going for a long time, when you imagine that they are built for medical use - I guess some patients need them going 24 hours a day?
Title: Re: Whoops!
Post by: Lush! on February 05, 2011, 05:55:49 PM
Might not be good for your leccy bill though  ;D
Title: Re: Whoops!
Post by: kerensky on February 05, 2011, 08:12:57 PM
I once left my extraction on in my studio for 3 days, message received - need to spend more time at torch.... didn't notice a huge leccy bill though.
Title: Re: Whoops!
Post by: Mand on February 06, 2011, 08:45:22 PM
Quote from: Lush! on February 05, 2011, 05:55:49 PM
Might not be good for your leccy bill though  ;D

Shhhhh! DH doesn't know!  :-X :P ;) ;D