Text only | Text with Images

Frit-Happens !

Technical Forum => Studio/workspace/setup/equipment => Kilns => Topic started by: Karen on January 03, 2011, 04:07:51 PM

Title: Can a kiln be run off an extension lead?
Post by: Karen on January 03, 2011, 04:07:51 PM
I know I have seen the answer on the board somewhere I have looked ( probably not as well as I should have done)  can I run my kiln safely using an extension lead permanently? Or should I try and move my table and kiln back to nearer the socket
Title: Re: daft kiln question
Post by: sarah t on January 03, 2011, 04:10:42 PM
 yes should be fine ...make sure unravelled if a coil up one
Title: Re: daft kiln question
Post by: Karen on January 03, 2011, 04:14:45 PM
 ;D thank you for the fast reply
Title: Re: daft kiln question
Post by: Redkite on January 03, 2011, 05:46:29 PM
I would just warn not to share the socket with anything else with a high load. Ie don't put the kiln on a 4 gang with kettle, heater etc .but if it's the kiln on it's own, will be fine
Title: Re: daft kiln question
Post by: Lee - Kilncare on January 04, 2011, 11:24:16 AM
Sound advice all round I say ;)
Title: Re: daft kiln question
Post by: ♥♥Tan♥♥ on January 04, 2011, 07:16:51 PM
Can you rename your thread along more specific lines something like....Can I run my kiln off an extension lead. It will make it easier for others to find this info
Title: Re: Can a kiln be run off an extension lead?
Post by: ♥♥Tan♥♥ on January 09, 2011, 02:10:40 PM
Altered :)
Text only | Text with Images