Frit-Happens !

Technical Forum => Studio/workspace/setup/equipment => Oxycon/Oxygen/Propane => Topic started by: Teddie on February 11, 2010, 04:48:14 PM

Title: My oxycon keeps overheating.
Post by: Teddie on February 11, 2010, 04:48:14 PM
My oxycon keeps overheating. I am working in my shed which is cold at the moment. I have only had my oxycon since mid January, sometimes the orange light comes on and then goes off. Now the red light will come on and it overheats. This is after about 2 hours at the torch. Anyone had similar problems?  :(
Title: Re: My oxycon keeps overheating.
Post by: ♥♥Tan♥♥ on February 11, 2010, 04:52:44 PM
It sounds as if it could be faulty, and it sounds as if it is still new, I would contact the person you bought it off and see if you can replace it while it is still under some sort of warranty
Title: Re: My oxycon keeps overheating.
Post by: Teddie on February 11, 2010, 05:04:39 PM
I bought it from Off mandrel but it was supplied by Tuffnells.
Title: Re: My oxycon keeps overheating.
Post by: Karen on February 11, 2010, 05:35:04 PM
have you contacted them? they are both very helpful, I had a problem when I first got mine and Martin sorted out straight away , luckily it could be done over the phone
Title: Re: My oxycon keeps overheating.
Post by: Dragonfire Glass on February 11, 2010, 05:35:23 PM
Ring Martin - he'll probably be able to help.   :)
Title: Re: My oxycon keeps overheating.
Post by: Teddie on February 11, 2010, 06:15:24 PM
Thanks. I will ring them in the morning.
Title: Re: My oxycon keeps overheating.
Post by: kerensky on February 11, 2010, 07:21:43 PM
Martin will sort it out for you, I have to say that mine has been playing up this winter and I don't use it very much - only twice in the last two months, it just hates this weather.......
Title: Re: My oxycon keeps overheating.
Post by: theflyingbedstead on February 11, 2010, 08:36:43 PM
Oxycons HATE the damp...it can be fatal  :'(

So I bring mine in from the studio; keep it in the dining room and give the filter a hoover every now and then.
Title: Re: My oxycon keeps overheating.
Post by: Redhotsal on February 11, 2010, 08:43:29 PM
The fan is either buggered or has lost it's connection. Open it up (opens right down the middle - but make sure you unscrew the retaining screws first.)  Dont' know what model you have but you should look for a  a square black fan - about 5inches across. They usually have bayonet type connectors. It may have worked its way loose so make sure it is pushed right in. If it is and it's not working you will need a new fan.
Title: Re: My oxycon keeps overheating.
Post by: Teddie on February 13, 2010, 10:22:33 AM
I have spoken to Martin and he is going to take a look at it. Thanks everyone for your help and suggestions
Tracey x