Frit-Happens !

Lampwork => Common Problems => Topic started by: Chelly77 on April 21, 2009, 11:19:41 AM

Title: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: Chelly77 on April 21, 2009, 11:19:41 AM
Morning Ladies and Gents,

I have this afternoon off to have a play and try and figure out where I am going wrong.  I am now actually producing round beads, however when you look at their side profile you can see that they have have a slight tear drop shap to them.

Any ideas on what I am doing wrong?  Is my first layer of glass not even enough, am I not spending enough time shaping the bead?

Its driving me nuts :(

Any help would be brill
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: Soozintheshed on April 21, 2009, 11:20:48 AM
Sounds like your mandrel is slightly off horizontal when you are shaping?
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: Les on April 21, 2009, 11:22:44 AM
yep... what Sooz said.
Try drawing a horizontal line just behind your torch to act as a guide when you are shaping :)
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: clasicat on April 21, 2009, 11:28:38 AM
Quote from: Les on April 21, 2009, 11:22:44 AM
yep... what Sooz said.
Try drawing a horizontal line just behind your torch to act as a guide when you are shaping :)
What a good tip Les am gonna try that cos I am pants at making round beads  ;D
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: Chelly77 on April 21, 2009, 11:36:19 AM
So its not so important when I am applying the glass, only when I am shaping it?
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: Soozintheshed on April 21, 2009, 11:45:30 AM
A lot of people shape as they go, I just blob lumps on and shape later  :)
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: dinah46 on April 21, 2009, 11:48:55 AM
Quote from: Soozintheshed on April 21, 2009, 11:45:30 AM
...I just blob lumps on and shape later  :)

too much technical speak on this forum ;D

All my beads used to have a lovely dimple on one end and grotty hole on the other ???  I just learned to keep an eye on the angle I was holding the mandrel :)
Title: Re: Tear drop shaped beads...dam it they are suppose to be round :(
Post by: sarah t on April 21, 2009, 02:25:42 PM
when i spent my day with julie ...my beads were not a bad shape till i tried to check what shape they were  :(.......maybe a mirror to check rather than moving the mandrel ...but i guess really  its just practise and knowing glass better

and using a marver to make it look deliberate !!!

i quiet like lemon pip shaped beads if its any concellation lol